With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
With this guide you can transform an old telephone in a friendly device that uses your mobile phone.
Material: An old telephone. A 1cm piece of wood larger than your cell and the thickness of 18/20 mm. A piece of plywood the same size. A USB extensio...
Open the phone and remove everything you find inside.
Draw a rectangle with a pen the size of the piece of wood. In my case for a Galaxy S is 80x135. If you need to delete all the holes in the cabinet you...
With the cutter or jigsaw removed the piece of plastic which will be glued a piece of wood.
Now precisely shaped hole that you made using a file and the piece of wood as a measure.
Place your phone in the center of the piece of wood and draw all around the profile sure to draw a little wider.
With the jigsaw cut out the inside, be precise in the cut.
Smoothed with sandpaper good for the inside that were cut. At this point you have to practice a slot to make room for the USB connector to charge the ...
Take the piece of plywood and glue on the bottom of the piece of wood.
While everything dries prepare the USB ports. I took a laptop broke a piece of card with two ports, you must remove all the components soldered becaus...
Once cleaned and cut in the rear of the phone base to track and get an opening.
When you have done the opening, make a hole 4 mm in the base, bring it on the basis of the phone and punched too. Insert a long screw that fastened wi...
Take the piece of wood that has been dried and sand it in all its parts. Then close the phone and placed the wood in the hole that you have obtained, ...
Reopen the phone, and with the hot glue to fix the piece of wood.
While waiting for the glue to cool, cut the extension cable and drilled on the side of the cave that you have done for the USB ports.
At this point you have to fill the conjunction of the piece of wood and the plastic of the phone. You can use a car body filler. When the filler is dr...
Now your device is ready to be painted. For a better grip of the paint can first apply a primer for plastic.
When the paint has dried, insert the USB cable and peel a few centimeters. Use only the red and black wires. Locked with a cable clamp to prevent leak...
Solder the two wires on the legs of the two USB ports. Follow the diagram and photos to weld them in the appropriate places. The red wire is + and bla...
Now you can place the base on the screw, adjust the height by the end of the nut and lock it with another nut. With hot glue attach the cable and also...
Before closing the phone permanently glued to one of the old keys to close the holes that had remained open. At this point it is necessary to coat t...
Cut pieces of cardboard to be inserted at the bottom to calibrate the depth of the housing, then coated with a soft material on the bottom.
Well, the phone is finished, you just insert it into your cell.
Now think: beautiful and functional but the handsets where is? The handset has been done previously with this guide. If you want a touch of class you ...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »