Analog Fabric Joypad

Step 2 Pattern making and tracing

Using the compass, draw a circle with a 5.5cm radius on the paper or cardboard. Using scissors cut the circle out and mark the center. Divide the circle through the center into four equal sections. Give these sections about .5 cm space between themselves, 1.5 cm to the edge and 1cm to the center. Cut out these inner sections with the cutter.

Now trace this circle onto the neoprene three times:

1 x TOP: just the outline
1 x INPUTS: as it is (outline and sections). Remember to leave a little tag that is not included in the pattern!
1 x VCC: outline and inner circle line (see picture). Remember to leave a little tag that is not included in the pattern!

Now cut out these circles. Just the outlines (remember the tabs!) and nothing from the inside!