Print PDF
Favorite
Email
Step 8Prepare the Frame End
For this step you will need to start by drilling a hole through each side (9/64" Bit) of the front top of the Frame.
Next cut the bottom of the front channel out, about 2-3 cm from the top(See 3rd picture).
Now bend the sides outward and align the ends upward. This is so the Flexinol doesn't have to work as hard to lift the pumpkin.
Next cut the bottom of the front channel out, about 2-3 cm from the top(See 3rd picture).
Now bend the sides outward and align the ends upward. This is so the Flexinol doesn't have to work as hard to lift the pumpkin.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
