loading

Step 5: Hyper extension plates


5. Now that you have the basic joint system you need to put an anti hyper extension plate on top. Use one of the one inch pieces as followed, if one inch does not work go ahead and make it a tad bit longer. Go ahead and place glue on where the black markings would be on your piece of wood be very careful to not be messy. (stray glue could kill the joints movement.) USE PHOTOS AS REFERENCE. Repeat these steps for each finger besides the thumb.
I agree with kiteman
This is cool, but it would be even cooler to see a short video of it in action.<br><br><sub>(Upload it to YouTube, then embed it here, and the video will drive views to your project as well.)</sub>
i did try to embed the video im not sure why its not working<br> there is a link below<br>
You have to use the &quot;old&quot; embed code:<br> <br> &lt;object width=&quot;480&quot; height=&quot;390&quot;&gt;&lt;param name=&quot;movie&quot; value=&quot;http://www.youtube.com/v/1sdb6X4M9Fg?fs=1&amp;amp;hl=en_GB&quot;&gt;&lt;/param&gt;&lt;param name=&quot;allowFullScreen&quot; value=&quot;true&quot;&gt;&lt;/param&gt;&lt;param name=&quot;allowscriptaccess&quot; value=&quot;always&quot;&gt;&lt;/param&gt;&lt;embed src=&quot;http://www.youtube.com/v/1sdb6X4M9Fg?fs=1&amp;amp;hl=en_GB&quot; type=&quot;application/x-shockwave-flash&quot; allowscriptaccess=&quot;always&quot; allowfullscreen=&quot;true&quot; width=&quot;480&quot; height=&quot;390&quot;&gt;&lt;/embed&gt;&lt;/object&gt;<br> <br> Which gives you:<br> <br> <div class="media_embed"> <object height="390" width="480"><param name="movie" value="http://www.youtube.com/v/1sdb6X4M9Fg?fs=1&amp;hl=en_GB"><param name="allowFullScreen" value="true"><param name="allowscriptaccess" value="always"><embed allowfullscreen="true" allowscriptaccess="always" height="390" src="http://www.youtube.com/v/1sdb6X4M9Fg?fs=1&hl=en_GB" type="application/x-shockwave-flash" width="480"></embed></object></div> <br>
your the man!
I agree.

About This Instructable

7,273views

56favorites

License:

Bio: https://www.kickstarter.com/projects/1779178928/the-beta-wallet-capo/description
More by LucasOchoa:IPhone 5 Screen Replacement  3D Printed Twisty Bracelet Steampunk Light Bulb Piggy Bank 
Add instructable to: