Step 1: Parts List
3 inch connector from the big air ball tower set (the one that connects the tubes of the air lift.
4 white rods
4 black or green tiny rods (the ones you connect connecters with).
4 red right angle
Step 2: Build the Parts
Pic 2: Build one of this
Step 3: Put the Rubberband On
Put the rubber band over one end of the tube, then bring it down the sides through the orange things sticking out, as shown in pic, the bring it sideways to the front, and twist it around that third thing sticking out. If you cant twist it right, check the close up pic. Please comment on this pic.
Step 4: Build It!
Pic 1: Attach the snowflakes as shown.
Pic 2: Attach the right angle connectors to the white rods as shown
Pic 3: Top view.
Step 5: Loading and Firing
To load this, simply stick one end ot the ammo through the snowflake and down into the rubberband, then grab the rubberband and the end of the rod and pull back until the grey rod is almost out of the aimer snoflake. Then, let go and watch it fly. The pic below is the loaded weapon.