One day Pak'e sold an old crank telephone, you know da kine, you crank to summon the operator named Sara to ask her to connect you to Sheriff Andy, to a nice old lady that probably remembers Using one.
After the sale the lady stayed a while to talk story with Pak'e, the owner of the store.
It came to pass, during the conversation, that she wanted to use the phone as an extention to her existing phone line.
She did not care if she could use it to call out.
The Pak'e said he knew of a guy that could do the job.......
Step 1: Basic Materials:
1 Antique Handcrank Telephone
1 Modern Telephone Handset
Hot Glue Gun
Hot Glue Sticks
2 Hollow Non-Conductive Tubes
Step 2: The Handcrank Telephone:
When the phone is open you will notice a very large empty box at the bottom of the phone.
This is where the modern phone will go and where all the wiring will be extended from and to all the various antique phone parts that may or may not work.
This telephone has a handcrank generator that produces _ _ volts that vary with the speed at which it is turned.
It is truly Wild electricity.
There is no battery in this phone.
Step 3: Various Parts (upper section):
2) The Mouthpiece
3) The Box
4) The hang-up Switch
5) The Capacitor (not used)
And Parts Is Parts.
Step 4: More Various Parts (lower section):
It is where the modern phone is installed, connecting wires are run, and hot glued in place for neatness.
See picture for parts placement.
Step 5: Antique Microphone Exposed:
Put it in a safe place where it wont fall. It is a brittle as glass.
The internal mic must be removed to install a modern mic as the old one will not work with the modern phone.
See the pictures for detailed removal instructions......
Step 6: The Modern Microphone Install:
Step 7: The Hand Set:
DO NOT BREATHE THE DUST FROM THE WIRE IT IS ASBESTOS.
The wire insulation is white. This is the asbestos. If you spray it with a clear craft spray you will make it safer as the asbestos will be less likely to turn to dust and fly around into your lungs after you coat it with the spray.
When you do this you are encapsulating the asbestos. Encapsulation is not perminant.
It is best to replace the wire with something safer and newer. Do not take chances.
Step 8: Wire Routing:
Maybe you have seen a wire harness from a car where all the wires are tied with string or zip ties?
That is what you are looking for.
Gee..... This sounds like it could be another instructable........Same Bat Time, Same Bat Channel !