Print PDF
Favorite
Email
Step 4Fitting the Power Supply
This step is also optional, as it's perfectly acceptable to have an external power supply. I've got quite a selection of power supplies that I've collected over the years from outdated gear (i.e., cordless phones) and just happened to have a relatively flat one that fit in this case.
Since the power supply had the power prongs sticking out of the back of it, I first had to remove them by desoldering, then replaced the prongs with a power cord. If you're lucky, your power supply will already have a cord!
After some playing around, I found a nice spot for the power supply that required only minimal modification to the floppy drive's internal frame.
Since the power supply had the power prongs sticking out of the back of it, I first had to remove them by desoldering, then replaced the prongs with a power cord. If you're lucky, your power supply will already have a cord!
After some playing around, I found a nice spot for the power supply that required only minimal modification to the floppy drive's internal frame.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
