Introduction: Arduino Christmas Notifier

Picture of Arduino Christmas Notifier

Christmas is just around the corner now, and I've concluded that I will not let it go by just having my DIY Arduino Christmas Lights. What would be a perfect project involving a Christmas melody? Yes, right! Letting people know that it's Christmas time sounds right enough. Let's begin!

Step 1: Parts Needed

Picture of Parts Needed
  • Breadboard
  • USB Cable
  • Buzzer
  • Arduino UNO
  • 6 Jumper cables
  • HC-SR04

Step 2: Connecting the Ultrasonic Sensor

Picture of Connecting the Ultrasonic Sensor

The sensor connections are as follows:

VCC goes to Arduino 5V Pin

GND goes to Arduino GND

TRIG goes to Digital Pin 5

ECHO goes to Digital Pin 4

Step 3: Connecting the Buzzer

Picture of Connecting the Buzzer

The buzzer is pretty simple - take the look at it's sticker at the top. The plus side is marked with a little sticker that I've removed. If yours do not have a sticker, take a look at the buzzer's surface, it should have the + symbol written over there. You need to connect it to pin 10 (can be changed in the code). The negative side connects to a spare ground pin of the board.

Step 4: Uploading the Code

Picture of Uploading the Code

The code for the melody is not written by me! I've found it on the Internet and decided to put the whole project together using it. You can find it here. You can modify some parts like the pin numbers and each tone of the melody to tune it however you like.

Step 5: Showcase

Above, you can see a simple video showing the contraption in action


NathanR124 (author)2017-12-21 But Google already lets me know when Christmas is here. That's December 25th.

Sure thing, you can use google. I've just wanted to create something Christmas-related.

About This Instructable




Bio: Student, currently studying programming. Interested in Arduino, Raspberry Pi and Electronics in general.
More by Aleksandar Tsvetkov:Arduino Reflex TesterArduino Christmas NotifierArduino Christmas Lights
Add instructable to: