Introduction: Arduino Internet Controlled Led's
In this project i'm going to control led's trough a webpages. You can open your browser and control the led's.
The code provided when uploaded and connected to the internet it creates a webserver in your LAN and you simply use the IP to access that webserver through your browser. After that it shows a webpage similar to that one below. When you press the button “Turn On LED” your url will change to: “http://192.168.1.177/?button1on” the arduino will read that information and It turns the LED On.
By default the IP is “192.168.1.177”. That also can be found on the arduino code provided.
Step 1: You Can Watch the Video!
You can watch this video or you can skip this video and go to step 2.
Step 2: Hardware
plug in the ethernet shield into your arduino. Connect your led's to digital pin 6. Make sure you use a resistor if you need one.
Step 3: Code
Upload the code. the files are here http://bit.ly/1jWYhJt.
Step 4: The Internet Page
When you have pluged in your Arduino you need to go to the page were you can control the led's. type in your webpage the folowing link: 192.168.1.177 if this one is not working you can go to the serial monitor of your arduino. There you can read your adress.
Step 5: TechMaker
If you want you can always subscribe on my channel on youtube and follow me on other networks. they are linked below.
✖ YouTube http://bit.ly/1WIMuNx
✖ Twitter: https://twitter.com/TechMaker_TM
✖ Facebook: https://www.facebook.com/TechMakerOfficial