Introduction: Arduino Light System

Picture of Arduino Light System

To make this arduino light system you will need the folowing.

7 jumpers

6 LED's

1 arduino

1 breadboard

6 220k resistors(red,red,brown)

1 10k ohm resistor(brown,black,orange)

Step 1: Angle 1

Picture of Angle 1

Each step from now on will just be of photos on how to setup your Arduino Light System.

Step 2: Angle 2

Picture of Angle 2

Step 3: Angle 3

Picture of Angle 3

Step 4: Angle 4

Picture of Angle 4

Step 5: Angle 5

Picture of Angle 5

Step 6: Finished Project

Picture of Finished Project

Step 7: First Par of the Code.

Picture of First Par of the Code.

Step 8: Second Part of Code.

Picture of Second Part of Code.

Comments

jacobtschiele01 (author)2016-05-22

I'm sorry but there should be 9 jumpers and a photoresistor

If you want to edit the Instructable, there is an EDIT button on the right side of the page that will let you go back into the editor to make any changes that you need to.

About This Instructable

392views

4favorites

License:

More by jacobtschiele01:Arduino Light System
Add instructable to: