Print PDF
Favorite
Email
Step 4Programming
The first thing I did was to erase the microcontroller on my Arduino by uploading a sketch without disconnecting the board before. SO BE CAREFUL NOT TO DO THAT!
Newer versions of the Arduino should be smart enough to avoid this by themselves, but it's not that much work to disconnect the shield before uploading....
To test your board I would recommend to use the sketch from here: http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1187962258/
Newer versions of the Arduino should be smart enough to avoid this by themselves, but it's not that much work to disconnect the shield before uploading....
To test your board I would recommend to use the sketch from here: http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1187962258/
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
