Introduction: Arduino - TM1637 7 Segment Display & DHT11 Temp Sensor

Picture of Arduino - TM1637 7 Segment Display & DHT11 Temp Sensor

Hello world! Today i made a simple Temperature & Humidity Meter with the TM1637 7 Segment Display & DHT11 temp sensor. Follow the next step for the Schematic, Code & Parts list.

This is very easy to build, I made it because i have no temperature meter at the attic. SO a simple cheap option is to build this simple device with arduino.

Step 1: Schematic, Code & Parts List.

Picture of Schematic, Code & Parts List.

Simply wire it up as the Schematic shows, and upload the code.

Make sure you have the below Libraries installed, i attached them to download.

  • #include "dht.h"
  • #include "TM1637.h"

Parts list.

  1. Arduino uno, I used the RobotDyn Uno. (has 8 analog pins)
  2. TM1637 7 Segment 4 Digit Display.
  3. DHT11 KY-015 Temperature sensor.
  4. Jumper wires Set MM/MF/FF

Good luck! Follow me for more!

Comments

vandenbrande (author)2016-08-26

Follow me for more!

About This Instructable

2,911views

7favorites

License:

Bio: Hello world! I make simple & Advanced projects for people who want to learn programming and electronics. Most of my Instructables are about arduino and the ... More »
More by vandenbrande:ARDUINO - SOLID STATE RELAY FAN/ventilator Control Using the W1209 Thermistor and SSR-25 DA Arduino - SSR-25 DA Solid State Relay and DS3231 RTC Automatic Timer Lamp Arduino & C# - RGB LED / LED STRIP CONTROL C# Application
Add instructable to: