Hey guys, Today we have a great project for you. Arduino Voice recognition! We use the Easy VR and an Arduino. This project will teach you how to use the easyVR for Voice recognition: Note: Voice recognition is different from speech recognition, voice recognition recognizes only a single person's voice, while speech recognition can recognize everybody's voice.

Submitted by Newton Labs for the Instructables Sponsorship Program

Step 1: Part List

EasyVR-Arduino shield: here!
||
OR EasyVR: here!
--------------------------------------------------------------------------------------------------
Arduino: here!

Step 2: Wireing

EasyVR TX->Arduino Pin 13 EasyVR RX-> Arduino Pin 12. Arduino 5V-> EasyVR 5V. GND->GND|||||||||||||||| Or if you have a shield, just put it on your Arduino. (If you can't tell where my wires are running in my pictures, then refer to the Circuit diagram made on Fritzing)

Step 3: EasyVR Library

You can get the library here!
You can get the EasyVR Commander here
You can get the Arduino IDE Software here! (if you don't have it yet)

Step 4: Programming

Make sure to have the easyVR-arduino library installed. Upload one of the samples. Then open the easy VR program, and program some commands (microphone required) by recording your voice. (Read pictures)