UPDATE: Now it works with IDE 021
Step 1: What you gonna need?
Step 2: Plugging all together
Plug the RFID sensor to the protoboard like the second photo above.
Only 3 wires are required to interface, 2 wires for supply and another for the serial line(communication)
The wires as connected as the third photo shows.
On RFID sensor: PIN 1 -> Tx
PIN 2 -> Rx (Not Used)
PIN 3 -> NC
PIN 4 -> GND
PIN 5 -> VCC (+5V)
Tx from RFID board goes to Digital PIN 2 on Arduino Board.
That is all you gonna need to wire.
Moving on to next step, the software.
Step 3: The code
I don't make any kind of checksum at the tags code, but it seems to work fine.
The code is really simple. I used a new library for the serial, using software emulation.
With the two white cards you can deny or allow the access of others keys.
Any doubt, please ask me.
code update for new Arduino version
Step 4: Results!
The video demonstrate how to use the software. I didn't post any kind of explanation as text on the video. I hope that the images spokes more then words, xD
Any doubt or suggestion, feel free to ask, or correct me.
Please, if you like it, rate it,