Step 4: Repair
Any sufficiently ambitious child will, at some point, attempt to stuff too many markers into a roll. It will burst. When this happens:
Cut a new roll lengthwise on an angle.
Put the cut roll tightly into the burst roll and mark it for a flush fit.
Cut the new roll on the line and apply glue.
Insert new roll tightly into the burst roll. Allow to dry
Re-paint.
Now the tube is even stronger than before.
Cut a new roll lengthwise on an angle.
Put the cut roll tightly into the burst roll and mark it for a flush fit.
Cut the new roll on the line and apply glue.
Insert new roll tightly into the burst roll. Allow to dry
Re-paint.
Now the tube is even stronger than before.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
