What you'll need:
A Chi-qoo Kit -- The kits are available for purchase from the BootstrapSolar website, but since it's Open Source, you could theoretically make your own from scratch too!
#1 Philips Screw Driver -- That's the "+" type, and a pretty small one.
Glue -- Any glue that works with wood. Standard wood glue will work, though "5 minute" epoxy probably offers the best balance between bonding strength, time to undo mistakes, and curing time.
Time -- Most folks have reported finishing the kit in an hour or less (and as little as 10-15 minutes for those who are handy).
Step 1: Check your components
6x wall sections (thin bamboo sections)
1x USB port bezel (says "USB 2" and "i-devices")
1x DC port bezel (says "A" and "B")
1x bamboo bottom plate
1x plastic top plate
1x 6000mAh Lithium Polymer battery
1x USB charger circuit
1x Solar charger circuit
1x Double-ended cable
4x roll pins
16x 3/8" #2 screws