Atomic Zombie's Granny's Nightmare bicycle chopper

Step 20 Two plates form the top of the triple tree.

The fork will use the conventional triple tree with a top plate bolted to the top of the fork legs, but with a slight difference - it will include the gooseneck as part of the plate. Rather than makeg a single plate and then fastening a handle bar clamp to it, I decided to use two smaller plates that will fasten directly to a gooseneck. This way, the original bicycle parts, including the handlebars could be used.

I started by cutting a few inches of 1.5 inch flat bar as shown in Photo 21. When bolted to the nuts that are welded into the fork tube, these plates will form a cap between the gooseneck and the fork tops as will be seen in the next few steps.