Instructables

Automated Answering System v1.0

Featured

Step 5: Attach Wires

Picture of Attach Wires
step5B.JPG
step5C.JPG
step5D.JPG
step5E.JPG
step5F.JPG
step5G.JPG
step5H.JPG
Wrap the a red and black wire around the bluetooth headset and then glue it in place making certain to leave enough room to solder the ends of the wires to the bluetooth microphone terminals.

Attach a red wire to the terminal that the positive end of the microphone was attached to and a black wire to the terminal that the negative end was attached to.
 
Remove these adsRemove these ads by Signing Up
Tiller5 years ago
Hi. I love this idea. I have a quick circuit addition that you should consider. You should add a 1 microfarad, 25 to 50 Volt non-polarized electrolytic capacitor (A mono ceramic would work too) inline with the positive side of the microphone wire. This will remove the voltage so that you are not sending voltage to your playback device and potentially damaging the headphone or line out of that playback device.