Here is a video of how it all fits together:
The device checks pre-defined email mailbox once an hour. If a new email is received the camera takes a picture, saves it on a SD-card and emails the image to its owner.
Making of the camera was also an interesting journey I would like to share.
Step 1: Required Parts
This GSM modem is great because of its built-in POP3 and SMTP support. Although these protocols are not very complicated to implement having them implemented saves some time.
LinkSpite JPEG Camera
This is a great little device. Built-in JPEG compression support saves a lot of development effort. The camera produces a 640x480 image. The image is around 50K; it is small enough to rapidly transmit over a cellular network.
Sparkfun's microSD Shield
Although there are a few SD card circuits available I decided to go with this one because it is very easy to work with both in software (Sparkfun provides great APIs) and in hardware (again, thanks Sparkfun for built-in voltage conversion).
This micro-controller was a natural choice. Arduino Uno uses this chip, so there are plenty of libraries and examples out there. Unfortunately, Arduino Uno itself consumes too much power when it is in a sleep mode, so I had to build a board with more efficient power supply system myself.
TPS2020 and LM2936
TPS2020 is a great power distribution IC. It allowed me turning circuit components on and off as I needed it. LM2936 is an awesome regulator with really low quiescent current. Combination of the two parts allowed my circuit to consume as little as 0.14mA in sleep mode. It stretches battery life for up to a month on a single charge; the camera is powered by 5V from two CR123A batteries.