Step 2: Creating the Case
Cut a hole in the lid of the film case. (see picture 1 to see were to cut)
Now take apart the pen. (all you need is the cap)
Cut the pen cap at the very top and the long piece that hands off.
Place the pen cap in the hole of the film cap and then tape it so it will hold, put the film cap bach on.
It should now look like picture 3
Now take apart the pen. (all you need is the cap)
Cut the pen cap at the very top and the long piece that hands off.
Place the pen cap in the hole of the film cap and then tape it so it will hold, put the film cap bach on.
It should now look like picture 3
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
