BECOME A MAD CYBORG... part human, part dead computers (UPDATED!!!)

Step 2 MECHANICAL ARM (option A: spring action)

NOTE: Before start building the arm, first read the Step 3 "MECHANICAL ARM (Option B: motor action)".

MATERIALS:

- Damaged printer (the main piece of the arm)
- Other printers pieces and cases
- Three screen round bases (two with entries for the elbow, one perfectly round for the clamp base)
- CPU frontal piece
- Aluminum pipe
- Five speakers (four for the clamp fingers, one for the base of the clamp)
- Springs
- Plastic handles (I use a plastic spool of thread and the handle of a toy shovel)

Comments

[Pizzapie500]

I think I have the same printer! Is it a Desk Jet 623C? How'd you get it apart? Internally all the screws are very small and star shaped.

[M.C. Langer]

Well, if I can't extract a screw by the good way, I destroy it!!!

[aquariusacquah]

How do u remove the insides of the computer

[M.C. Langer]

Watch for step 1

http://www.instructables.com/id/BECOME-A-MAD-CYBORG-part-human-part-dead-compu/step1/A-lot-of-useful-and-important-blablabla-before-sta/

You can use a Dremel for cutting or devastating the edges, and you can use pliers for ter them.

[aquariusacquah]

I mean printer