Print PDF
Favorite
Email
Step 2The First Cut
I used 1 1/4 inch PVC for this berry picker. A smaller version, using 1 inch pipe turned out to be too small for the berries I was after, but might be good for smaller berries.
The first cut is made at quite a sharp angle. This gives you plenty of material to cut the two "fingers" out of.
Use a pencil to sketch out the cuts you are going to make.
The first cut is made at quite a sharp angle. This gives you plenty of material to cut the two "fingers" out of.
Use a pencil to sketch out the cuts you are going to make.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
