With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
In this instructable, I'm going to show you how to make a simple circuit/code with an arduino, which will make an LED connected to it flash from off t...
1 x LED 3 x Cables 1 x 330 Ω Resistor 1 x Arduino board (it can be any kind, but for this instructable i used the UNO board). 1 x USB cable 1 x Comput...
Firstly you will need to plug one end of a wire into the '5v' Power output on the arduino, and the other end into the positive section of the breadboa...
Attach a wire from digital port '0' on your Arduino to the hole directly above the resistor.
Now to attach the Led into the circuit. Be warned, it will NOT do anything until you have uploaded the code to the board, which is done at a later sta...
Now you need to plug the arduino board into the computer. Nothing really to say here, just make sure that you don't break anything!
I've attached the code here. All that you have to do is open it with the arduino sketch program, and click upload to device
Once the code is uploaded, if you have done everything right, the LED should flash. It will do that for as long as the device is plugged in. Note- if...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »