Print PDF
Favorite
Email
Step 7Instal cross beams
Turn the table on its side such that you can easily insert beams between both table legs in a vertical fashion.
Line up the "bottom" edge of the vertical post with the line you just drew and drill a thin pilot hole. Next fasten it in place with a wood screw. Flip the desk over 180 degrees and repeat.
Install the cross beam on the other side in a similar fashion.
Finally, install the cross beam that goes across the back by lining it up with the marks you made earlier.
Line up the "bottom" edge of the vertical post with the line you just drew and drill a thin pilot hole. Next fasten it in place with a wood screw. Flip the desk over 180 degrees and repeat.
Install the cross beam on the other side in a similar fashion.
Finally, install the cross beam that goes across the back by lining it up with the marks you made earlier.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
