I think this is a very simple design most people are capable of making with fairly basic tools, cheaply and without advanced carpentry skills. it is a effective heater - I have seen the water on top reach 150F on a hot spring day.
I have built a few of these and am still working on improving the design. I will log in and update this as I have more pictures and info. If these are not completely clear directions, well, this is my first instructable, so it will only get better.
Step 1: Materials Needed
Double glazed patio sliding glass door, 3' wide ideal. Should measure about 36” x 79”
Old water heater tank. I have only used 40 gal gas heaters so far, but I see no reason why larger tanks and electric tanks should not work, fine.
½ inch sheet of plywood
5/8 inch sheet of plywood
2 sheets of 1 inch foam insulation with reflective foil surface
Rustoleum or equivalent flat black metal paint, 1 pint
Stain or exterior primer and paint, 1 quart of each
¾ inch steel plugs for extra tank holes, maybe.
2 cut off pieces of 2 x 8, 16” long
One tube of latex or other caulking
Box of 1 5/8” drywall screws
10 3" wood screws for tank supports
16" long 1/2" copper pipe with cap and
2" long 3/4" threaded steel pipe
JBWeld for above
Teflon pipe tape