Step 7: Assembling It
Soldering all the components... not much to say. None of the components are particularly heat sensitive... maybe the LED. Bend the LED 90 degrees so it sits against the board pointing forward.
I ended up putting the link from the LED to the negative terminal of the capacitor on the top side, rather than the bottom as I had on the sketch in step 5.
I ended up putting the link from the LED to the negative terminal of the capacitor on the top side, rather than the bottom as I had on the sketch in step 5.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
