Print PDF
Favorite
Email
Step 14Reassembly
To finish assembly, fit the faceplate inside the bottom half of the case. The faceplate lip should be inside of the case lip to hold it in place.
You may want to place some electrical tape on the motor if you think the diode D1 is at risk of shorting to the motor case.
Put the gears and handle back in their original positions. Consult the photo below to see how they are oriented in the case.
Put the top half of the case on top of the bottom half. The two parts should fit closely together if the step-up converter was made pretty closely to the one in this Instructable.
Flip the new and improved power supply over and tighten the four screws.
You may want to place some electrical tape on the motor if you think the diode D1 is at risk of shorting to the motor case.
Put the gears and handle back in their original positions. Consult the photo below to see how they are oriented in the case.
Put the top half of the case on top of the bottom half. The two parts should fit closely together if the step-up converter was made pretty closely to the one in this Instructable.
Flip the new and improved power supply over and tighten the four screws.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
