Print PDF
Favorite
Email
Step 9Preparing the faceplate
Note: not all dynamo keychain flashlights have a LED circuit board. If yours does not, you can skip this step.
A. Wedge a flathead screwdriver between the faceplate plastic and the LED circuit board.
B. Twist the screwdriver. The faceplate and LED circuit board should pop apart.
C. Find the nub on the plastic faceplate.
D. Clip the nub with wire cutters.
E. The nub side will face out in the new dynamo.
F. Desolder the LEDs from the LED circuit board. Try to extract the LEDs intact and leave the holes open for future pins.
A. Wedge a flathead screwdriver between the faceplate plastic and the LED circuit board.
B. Twist the screwdriver. The faceplate and LED circuit board should pop apart.
C. Find the nub on the plastic faceplate.
D. Clip the nub with wire cutters.
E. The nub side will face out in the new dynamo.
F. Desolder the LEDs from the LED circuit board. Try to extract the LEDs intact and leave the holes open for future pins.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
