Beer Bottle Drying Rack

Step 4 Assembly

Assembly can be just a bit touchy but if you check for alignment carefully, locating your legs shouldn't be too much trouble. I chose to attach the legs using four screws each.

1. Position the legs.

• Flip over the hard-board and place the legs where you want them.

2. Trace the outline of each leg with a pencil
3. Drill a pilot hole through the hard board inside of your pencil marks.
4. Flip the board right-side-up and carefully position the feet exactly withing the pencil marks.
5. Attach each leg with one screw.

• Locate a pilot hole you drilled in step 4.
• Drill down through this hole into the leg.
• Screw the leg and board together using this hole.
• Repeat for each leg, one screw only.

6. Inspect that your legs are still properly aligned.

• The single screw should hold the leg in place but allow for fine tuning.

7. Secure remaining screws

• Once alignement has been verified, drill pilot holes and drive in the remaining screws.