Print PDF
Favorite
Email
Step 4Run the tubing...
This is the easiest part. I started by attaching the t-joint to the right side of the helmet (used zipties of course).
From the bottom of the t-joint I ran one but to my mouth, which was pretty short (eight inches at most). Next the top of the joint runs in a straight line to the back left coozie (which can be switched to the front left if there is a cup there).
Finally, I fan the back of the t joint around the back of the helmet and looped it back to the right side (once again this can go in either the right back coozie or the right front cup depending on which drinking mode you're in).
From the bottom of the t-joint I ran one but to my mouth, which was pretty short (eight inches at most). Next the top of the joint runs in a straight line to the back left coozie (which can be switched to the front left if there is a cup there).
Finally, I fan the back of the t joint around the back of the helmet and looped it back to the right side (once again this can go in either the right back coozie or the right front cup depending on which drinking mode you're in).
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
