Introduction: Bic Lighter Refil

Picture of Bic Lighter Refil

What u gonna need; push pin, can o butane, dremel tool, and an empty lighter.

Step 1: Dremel It

Picture of Dremel It

Dremel out a hair, like less than 8th or chip it safely, I won't be held responsible. Little Bic this step is not required.

Step 2: Punch It

Picture of Punch It

As seen on next step

Step 3: Punch It

Picture of Punch It

Use a push pin jab it right through the middle. These things have made a fortune of us, not anymore.

Step 4: Fill It

Picture of Fill It

Just like a refillable, tip the butane up and fill. This should take approximately 5-10 sec depends entirely on the amount of pressure in the can.

Step 5:

Step 6: Plug It

This is the trickiest part, but for a professional lighter modification expert like I inspire to be it is overshadowed by glory. As soon as that can comes off the lighter put yo finger over it, followed by a push pin.

Step 7:

Picture of


chiujunk (author)2017-01-20

Dremel not needed, just poke it with the tack

Swansong (author)2016-12-02

Thanks for sharing :)

About This Instructable




More by Artvark1625:Bic Lighter Refil
Add instructable to: