Introduction: Bicycle Repair Stand #2 (Portable)
This is a stand supported by a 35 lb cast iron stand used for an 10' wide umbrella. It's more than ample to support a bike for repair.
Step 1:
This is the shorter pvc extension.
Step 2:
This is the taller pvc extension.
Step 3:
Bar clamp holds bike bar, this detail was covered in my previous instructable.
Step 4:
Slope bar attachment
Step 5:
Another view of slope bar attachment. This configuration allows for sloping the bike to any ange.
Step 6:
Using alternate top attachment for slope or vertical bars.
Step 7:
All components for stand.
Step 8:
The base & steel tube attached to base for support.
Step 9:
Base & tube tilted over for view the bolt attachment to steel tube - this is the umbrella stand as purchased from retailer. The rust has no structural value.