Step 5: Bonus: USB Bracelet
Cut a strip to the correct width to fit the flash (e.g. Transcend Ultra-Slim Metallic Flash Drive
) drive between two stitches. I used a racing bicycle tube, because it had the perfect width to begin with.
Put the flash drive between the stitches and cut a slot, through one of the layers (as shown in the third picture). All that is left to do is to add an press fastener and you are good to go.
) drive between two stitches. I used a racing bicycle tube, because it had the perfect width to begin with.Put the flash drive between the stitches and cut a slot, through one of the layers (as shown in the third picture). All that is left to do is to add an press fastener and you are good to go.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
4
ray74
says:
Dec 9, 2012. 7:34 PMReplyVery creative.
Visit Our Store »
Go Pro Today »
