Print PDF
Favorite
Email
Step 7Creating The Blinker Case Part 2
Next you want to mark where you want to drill the holes for your leds, and then drill the holes. This was not too hard, i used a power drill.
After that, check the leds and see if they fit, if they don't drill out the hole a bit more, I made my holes just small enough for the leads but not the whole bulb.
After that, check the leds and see if they fit, if they don't drill out the hole a bit more, I made my holes just small enough for the leads but not the whole bulb.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
