Big lamps from Ikea lampan lamps

Step 3 Burn the holes

Print out the appropriate page(s) of the template PDF. Mark the holes with a pen and burn holes with a soldering iron. The tire-wraps should go easily through the holes. Burning holes in plastic is not so nice, but easier than drilling. So open a window or do it outside.

Comments

[surfturf]

Its a uite "steep learning curve" here from unpacking the lamps to Print out the appropriate page(s) of the template PDF". Maybe you should present the pdf:s and the usege of those holes earlier? Good idea though. I WILL make this one..