Print PDF
Favorite
Email
Step 2Get the Materials
Here is all the materials I used to build BikeGen.
Raw Materials
Aluminum Angle 3/4"x3/4"-1/16"thick
Aluminum Angle 1-1/4"x1-1/4"-1/16"thick
#6-32 All-thread
Hardware
4 - #6-32 nylon-lock Nuts
2 - #6-32 x 1-1/2" long Machine Srews
2 - Springs
2 - 1/2" #4-40 Stand-offs
4- #4-40 x 1/4"long Machine Screws
2- #4-40 Nuts
Electrical Parts
18 gauge wire - roughly 25ft
2 - DPDT switches
12volt car outlet
2200 ohm resistor
Battery Holder for 2 AA batteries
D-Sub connectors
Everything used to make the Bike Generator
Other Needed Items
Small Plastic Organizer Box
Raw Materials
Aluminum Angle 3/4"x3/4"-1/16"thick
Aluminum Angle 1-1/4"x1-1/4"-1/16"thick
#6-32 All-thread
Hardware
4 - #6-32 nylon-lock Nuts
2 - #6-32 x 1-1/2" long Machine Srews
2 - Springs
2 - 1/2" #4-40 Stand-offs
4- #4-40 x 1/4"long Machine Screws
2- #4-40 Nuts
Electrical Parts
18 gauge wire - roughly 25ft
2 - DPDT switches
12volt car outlet
2200 ohm resistor
Battery Holder for 2 AA batteries
D-Sub connectors
Everything used to make the Bike Generator
Other Needed Items
Small Plastic Organizer Box
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
