Print PDF
Favorite
Email
Step 3Assembly
10. Snap the keyboard portion back onto the main body.
11. Snap back in the side case rails, and make sure they are both in tight! The Torx screws go threw the holes in them.
12. Tighten all screws back into place. (And reattach moisture detection slip if necessary)
13. Snap bottom case back on, this time the reverse, put the front in then pull towards the back.
14. Drop back in the trackball assembly, making sure it has the right orientation, then snap the retention ring back in, also with the right orientation!
15. Pop the battery back in and wait for it to light up!!
11. Snap back in the side case rails, and make sure they are both in tight! The Torx screws go threw the holes in them.
12. Tighten all screws back into place. (And reattach moisture detection slip if necessary)
13. Snap bottom case back on, this time the reverse, put the front in then pull towards the back.
14. Drop back in the trackball assembly, making sure it has the right orientation, then snap the retention ring back in, also with the right orientation!
15. Pop the battery back in and wait for it to light up!!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
