Print PDF
Favorite
Email
Step 2Prepare the LEDs
Unless if your LED is already a flat-top, you'll have to grind/sand/cut it down to that the top is flat, and not far (within 1mm or 3/16") from the LED glowing element. There's not that much room to shove a whole LED in.
We used a sanding belt to bring it down to size, but see how it leaves the top an opaque white? Here's a trick: Rub the flat face against a sheet of paper for a full minute. It brings up the polish quite well, and if the face is fairly smooth, you can almost get it back to stock clarity.
We used a sanding belt to bring it down to size, but see how it leaves the top an opaque white? Here's a trick: Rub the flat face against a sheet of paper for a full minute. It brings up the polish quite well, and if the face is fairly smooth, you can almost get it back to stock clarity.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
1
Dec 7, 2011. 3:20 PMBeergnome
says:
Ive seen dirtier nails... Im looking at some right now!
Reply
Jul 21, 2011. 12:36 PMnigel cox
says:
A great instructable, will be having a go myself, after polishing the led on the newspaper add a drop of clear nail varnish this should bring it back to original spec, regards Doc Cox
Reply
 |
Add Comment
|
