Introduction: Blinker Circuit With Timer EN555P and Resistors DIY Experiment

Here is shown how to plug a blinker circuit quick and easy.

Step 1: Materiallist and Schematics

What you need:

Power Source (USB TTL Module 3,3V OUT)

Breadboard

Jumper Wire

Bridge or Cable

2 X Resistor 1K Ohm

Resistor 560 Ohm

Timer NE555P

LED

various Capacitors for Blinkfrequency:

16V-22Uf/33uF/47uF/100uF/120uF/220uF/330uF/470uF/
680uF/10 00uF/1200uF/2200uF/3300uF

Plug all together as shown in schematics and test it.

Comments

author
seamster (author)2014-10-29

Nice!

author
bastelking (author)seamster2014-10-30

Thx, I do my best :)

About This Instructable

380views

8favorites

License:

Bio: I like to get back to the technical roots and try to make things without getting too complicated. Thanks for feedback https://www.youtube.com ...
More by bastelking:Sparebots selfmade electronic waste DIY Project Sparebots selbst gemacht aus Elektroschrott DIY Projekt Anleitung Wechselblinker Schaltung mit NE555P Timer
Add instructable to: