Print PDF
Favorite
Email
Step 6Inserting the Headset into the Gun
Hook a rubber band over the trigger arm (see picture). Let the other end dangle out of the bottom of the gun for now.
Cram the headset into the gun where the magazine used to be. notice how the microphone portion points down (so you can talk into the handle) and it's pressed against the upper portion of the headset. The headset fits perfectly so you don't need to secure it, just stuff it in there. Make sure the rubber band stays on the trigger arm side of the gun.
The pin coming off the trigger arm should be just off the call start/end button so that when you pull the trigger it operates the button.
Cram the headset into the gun where the magazine used to be. notice how the microphone portion points down (so you can talk into the handle) and it's pressed against the upper portion of the headset. The headset fits perfectly so you don't need to secure it, just stuff it in there. Make sure the rubber band stays on the trigger arm side of the gun.
The pin coming off the trigger arm should be just off the call start/end button so that when you pull the trigger it operates the button.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Jul 17, 2008. 7:55 AMaakash734
says:
Hey, I was just looking at this and planning on making it, but once its made how do you charge the bluetooth headset inside the gun?!
Reply
10
Jul 17, 2008. 2:11 PMMisterHay
says:
Maybe you could make a "clip" containing batteries that comes out the bottom of the handle. The batteries could charge the headset.
Reply
 |
Add Comment
|
