Print PDF
Favorite
Email
Step 12Step Twelve
Using a mitre saw with box, table saw, table saw, or circular saw cut two 11-1/4" length sections and one 12" length section off of the 1/2" diameter plastic rod.
Mark the center of both ends of the rods.
Using a 7/64" bit in a drillpress or power drill drill to a depth of around 1/2 of an inch. Then tap the holes with a UNC #6-32 tapping bit.
Mark the center of both ends of the rods.
Using a 7/64" bit in a drillpress or power drill drill to a depth of around 1/2 of an inch. Then tap the holes with a UNC #6-32 tapping bit.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
