Introduction: Bracelet That Looks Like Braid
Step 1: Cutting Tape
First you want to cut 1 piece of tape a few inches longer than your wrist.
Step 2: Cutting in Half
Next you want to cut the tape in half lengthwise.
Step 3: Folding the Tape
Next you want to fold the tape lengthwise to get strips with no sticky showing.
Step 4: Weaving
Fold both pieces lengthwise in half to get a good crease. Then lay one piece on top of the other. On the bottom piece cut a slit about a half an inch away from the end, make it about the length of the x-acto knife.
Step 5: Weaving
Now pull the top strip thru the slit and pull until both ends are lined up.
Step 6: Weaving
Now cut a slit on the bottom piece (the piece that hasn't been cut yet) like you did before. Then pull the top piece thru it.
Step 7: Weaving
Continue doing those steps until you have the whole thing woven.