Instructables

This is an inexpensive means of keeping any number of brushes wet between sessions and while painting  with water based paints. It can also be used for hanging brushes to dry tip downward.
 
Remove these adsRemove these ads by Signing Up

Step 1: Materials needed


You will need:

1) A fairly deep square or rectangular water holder.  I bought surplus motel 'ice buckets' at a kitchen supply store.

2) Pipe insulation - approximately 1.75 inch diameter with a 1 inch center hole. (From any hardware store) Other sizes will probably work.

3) Something for marking where to cut the insulation - chalk, pastel, paint, sharpie - you just have to be able to see the marks

4) An Exacto knife... this will need a fresh blade!

Step 2: Cut insulation

Picture of Cut insulation

Cut a length of insulation to fit on a side of your container.


Step 3: Mark the area for cuts

Picture of Mark the area for cuts

Mark on the end of the foam where the brushes will fit without hitting the top rim of the container... You must leave enough room at the bottom (next to the tube opening) so that there is enough material to hold it all together.

Mark along the length of the insulation at those two points. You will not want to cut slits beyond these lines.


Step 4: Mark slits for brushes

Picture of Mark slits for brushes

Mark out slits for the brushes.
Bigger brushes need wider slits, so you'll probably want a variety of widths. The length of the slits will all be the same.
Important....The ends of the slits need to be bigger so that the foam doesn't just 'spit out' the brush when you push it in.

Step 5: Cut the slits

Picture of Cut the slits


Use an exacto knife with a NEW blade to cut your slits.

When done,  put the holder on your water container and try it out. You may find that you want to do more trimming.

Step 6: Dry brushes, too!

Picture of Dry brushes, too!

Bonus! Dry your brushes safely! You can put this brush holder on a weighted cardboard box to safely dry your (completely cleaned) brushes tip downward. Rocks, water bottles etc work well as weights.
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!