loading
This gun has a trigger that is realy easy to make and can be very strong with a lot of rubberbands. Start Building!

Step 1: The Handle

This is the handle.

Step 2: The Barrel

Follow the pics and you will get the barrel.

Step 3: Connecting the Handle and Barrel

Connect the handle to the back of the barrel.

Step 4: Trigger and Handle Support

Make the trigger and handle support. The handle support will keep the gun in shape when you pull the trigger.

Step 5: Attaching the Trigger and Handle Support

These pics will show you how to connect the trigger and handle support.

Step 6: Trigger Mech and Attaching

This is what will make the gun go off when you pull the trigger.

Step 7: Ram Rod

Make the ram rod and insert it in the back. If you are going to put a lot of rubberbands, tape it.

Step 8: Rubberbands

Put the rubberbands where they are shown. there are two rubberbands used on this gun. 1. A rubbband for the ram rod. 2. A rubberband for the trigger.

Step 9: Shooting

To shoot it, you pull the ram rod back till the trigger pulls up. Put any rod you like through the front and pull the trigger. Enjoy!!!
I wasn't trying to copy the spider massacre, I made it all my own.I one time did add a spinning barrel to it and it was a 8 shot. The barrel was all thanks to sypran.
bad copy of Spider Massacre...........but its not famous, so i think you never saw it.......... im not going to rate until this gets some more comments
all it needs is a clip.... Cool though
Has the shape of a revolver, awesome:)

About This Instructable

875views

1favorite

License:

Bio: Hey there,I am just a guy that likes to play horn in band and likes to hang out with my friends and I like ... More »
More by Bugman9:Bugman9's knex Glock New jose halapeno on a stick how to make. Knex jose halepinio on a stick. 
Add instructable to: