Build The $5 Microphone Preamp

Step 3 Off board wiring

For this step what has happened is the three chips are mounted to the enclosure and wires are connected inside. I would draw you a plan but everyone is going to be different.

If you are not using shielded wire, it is good to twist wires together; this protects from electromagnetic interference by cancelling out.

I also stacked the two boards on top of each other for a neater appearance and so that one is not randomly floating. It is the second picture.

In the end I didn't use the 4 diodes for clipping protection as it was just to much of a hassle to connect it all up.