Step 5: SMOOTHING THINGS OVER (PVC)
There may be some rough edges caused created during the cutting steps. (my plastic bottle melted a bit from the friction created by the hack saw).
Try fitting the bottle top over the end of the PVC tube as shown in the first photo of this step.
If they will not fit snugly together use a sander (or hand sand) to smooth the outer rim of the PVC tube.
I found that a Dremel with sanding drum attachment worked well on the inner rim of the PVC.
Try fitting the bottle top over the end of the PVC tube as shown in the first photo of this step.
If they will not fit snugly together use a sander (or hand sand) to smooth the outer rim of the PVC tube.
I found that a Dremel with sanding drum attachment worked well on the inner rim of the PVC.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
