Build a Paintball Mine

Step 10 Complete the top of mine.

Place the CO2 cartridge back inside of mine. Place plunger in cap and screw cap on. DO NOT over tighten!   Mark the plunger at 7/8” to 1” above top of cap. Cut the top of plunger off at the mark and then glue on the ½” cap.  

Comments

[tmckenzie1]

well i just built mine today and the problem im having is the co2 let out is shooting through the cemented pvc pipe that holds the co2 in place with the screw in it so i just re did it and set it out for the night and maybe if i keep re aplying it each day it will get stronger idk

[kaptaink_cg]

Hmm.. That's strange. Can you post a pic of the problem?

[camoguy1]

Now put some airsoft bb's in the tubes and some water behind it instead of paint... Viola! instant airsoft mine!

[thatoneguy112233]

i think that it would be better without the 4 spray tubes because without thhem you could get a wider range and possibly get more people, just my thoughts

[kaptaink_cg]

Without the 4 tubes, you can't truly "pressurize" the chamber. You'll probably get a bigger spray radius, but the CO2 will take the path of least resistance out, meaning it will just go straight for the holes and will leave at least half the paint behind.

[awesomepossum41]

 my cap wont screw on when the co2 tank is in it, and i followed the steps, so what can i do :-(

[awesomepossum41]

 Ok, i fixed it just sanded a part of the inside of the plunger :-)

[Undermig]

yea the union?