Build a Star Wars Boba Fett plywood wall plaque by rbird77
Featured

Step 5: Done!

step11.jpg
MaddyPeace640.jpg
peaceheart.jpg
TaylorsWonderWoman.jpg
horseshoeheart.jpg
batman.jpg
photof.JPG
photoe.JPG
GriffinsStormTrooper.JPG
You are only limited to your imagination on these.  On the Batman logo below I added some imitaion carbon fiber for the background and added some glow in the dark paint to the edges of the bat.  The peace signs used the photo paper and designs found online. 

If you would like a full psd or pdf set of any of the plaques that you've seen here, just message!

Enjoy!

5-7- 11 - Here's the boba fett package in a zip file - http://yourfavoriteweb.com/superman/bobafett.zip The file is about 22 megs and contains the templates for cutting and color plates for battle damage. Only the decal page needs printed at high quality on photo paper if you have it.

Here is batman - a 6 meg PDF - http://yourfavoriteweb.com/superman/batman.pdf
 
Remove these adsRemove these ads by Signing Up
Jon316 says: May 24, 2011. 6:38 PM
how did you cut out the mid section of the bat man symbol?
rbird77 (author) says: May 25, 2011. 5:35 AM
I used a dremel trio on that one but normally use a scroll saw. But, if you drill some pilot holes to start, you could use a jigsaw. Just be careful where you put the pilot holes if you are using plywood. The out lamanent can split, especially on the bottom. SO, don't drill a pilot too close to the edge that you will be cutting. Hope this helps!

Ron
Jon316 says: May 29, 2011. 5:00 PM
thats right i actually forgot about the dremel thanks.
Pro

Get More Out of Instructables

Already have an Account?

close

PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format. You also have the ability to customize your PDF download.

Upgrade to Pro today!