Step 1: Disassmble any USB simple webcab
This webcam cost me 5$ - very simple low resolution web cam.
Step 2: Place hot-glue over the electronic side of the camera so it won't get damaged.
Step 3: Remove the insolation from the cable & add a red and white wire.
Cut the red and black wires and reveal the copper wiring .
Connect two additional extensions for these cables (5V DC) and solder the red together and the blacks together (not red to black!)
Step 4: White LED connection
Then connect the black wire to the short LED lead.
Step 5: Connect the white LED
Remove the mirro from the bottom and connect a toothpick to the two holes that remain.
connect the LED to the toothpick with hot-glue.
Step 6: Connect the camera
After you find the exact location use a hot glue gun to fix it to that position .
Then tape the wires tidily to the microscope and start taking pictures...
Step 10: I hope you like my instructable - If you do - please rate it
= Please Rate on the right of the page
I love comments and feedback (good and bad)