Print PDF
Favorite
Email
Step 7Adding the mesh
Measure and cut two 11-foot sections of the 8-foot mesh. These will be long enough to fit crosswise over the hoops, with 6 inches on each ends to wrap around the base. Wire the mesh to the base by threading the 14-gauge wire through the mesh.
This would work better with thinner wire, or nylon string.
Go to the barn to get some string.
Come back 20 minutes later, no string.
Continue to wire mesh to frame.
At end, curl mesh around and wire together to close end off.
The Tractor is done!
Except for the door end, because you haven't figured out how to make the door yet.
Try out the Tractor by putting two rabbits inside. Push the tractor against the bunny pen while you get that piece of wood right over there to act as a door.
5 seconds later, both rabbits squeeze through the 3-inch gap and escape. Go catch them and put them back in their pen.
This would work better with thinner wire, or nylon string.
Go to the barn to get some string.
Come back 20 minutes later, no string.
Continue to wire mesh to frame.
At end, curl mesh around and wire together to close end off.
The Tractor is done!
Except for the door end, because you haven't figured out how to make the door yet.
Try out the Tractor by putting two rabbits inside. Push the tractor against the bunny pen while you get that piece of wood right over there to act as a door.
5 seconds later, both rabbits squeeze through the 3-inch gap and escape. Go catch them and put them back in their pen.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
